CDA HNG7410FR, Installation, Use And Maintenance Manual, Page: 24 / 40

24
Troubleshooting
On first use
On switching on
In use
You observe that Possible Causes What should you do?
Installation blows a fuse.
The electrical connection of the
hob is incorrect
Check that it is set up properly
(see the Electrical Connection
section)
You observe that Possible Causes What should you do?
The hob does not work and the
lights on the control panel do not
switch on.
Electrical connection fault. Check the power supply.
Protection circuit breaker or fuse
has tripped.
Replace the fuse or reset the
circuit breaker.
A small object, grease or water is
on one of the control keys.
Check the control keys are clean
and no objects are on them.
9
You observe that Possible Causes What should you do?
One or all of the zones cuts out.
The safety system has cut out.
Leave hob to cool then try it
again
A cooking zone has been
running for a very long time
Switch it on again (if required).
One or more control keys are
covered.
Clear any objects and clean
liquid from the control area.
A pan has boiled dry and is
overheating.
Remove the pan in question.
The fan continues to run after the
hob is switched off.
This is not a fault, the cooling
system is working correctly.
Nothing.
“U” flashes on the zone display.
The cookware used is not
suitable for induction.
See page 6 for information on
cooking on induction
There is no pan on the cooking
zone.
Place a suitable pan on the
cooking zone.
The bottom diameter of the pan
is too small.
Place a larger pan on the
cooking zone.