37
Locate the motor box and attach the conduit chamber to it using the
screws provided, as per Fig. 15. Loosely attach the chimney conduits
to the base section, raise them up to the hob extractor outlet and
fit them as though you were completing the conduit section install.
Whilst another person supports the sections, ensure that everything is
aligned and nothing is being strained or twisted. Then, if you haven’t
already prepared the area and provided you are running the ducting
under the unit(s), draw a 410 x 410mm square around the motor box,
remove the box and conduits and cut the hole in the base of the
unit. Replace all of the components in the same order as above and
secure the lower conduit to the motor box as per Fig. 17.
Fig.15
Fig.17
Fig.16
Fig.18
