17
Should any error code other than those listed above show on the
zone displays, contact CDA Customer Care for assistance
IMPORTANT - PLEASE NOTE:
In the event of any breakage, crack
or cracking – even minimal – of the vitroceramic glass, immediately
disconnect your appliance to prevent a risk of electric shock and
contact CDA Customer Care.
You observe that
Possible Causes
What should you do?
The hob has stopped
operating. The hob beeps
and ER03 is displayed on
the zone display
There was an overflow or
an object is in contact with
the control panel
Clean the hob or
remove the object, and
begin cooking again
The hob has stopped
operating and the display
shows E2, ER21 or ER40
The electronics have
overheated
Allow the hob to cool
down.
See the Installation
section to check the
ventilation requirements
have been met
After turning on a zone, the
zone display shows
The cookware used is not
suitable for induction or
is less than 11cm on the
160mm zones, or 145mm
on the 200mm zones
See the section on
cookware for induction
The saucepans make noise
during cooking or your hob
makes a clicking sound
during cooking
This is normal with some
types of cookware. This is
caused by the transfer of
energy from the hob to the
cookware
Nothing. There is no
risk, neither to your hob
nor to your cookware
The fan continues to
function for a few minutes
after the hob is turned off
Cooling of the electronic
components.
Working normally
Nothing.
