CDA HG9321SS, Installation, Use And Maintenance Manual, Page: 10 / 28

10
Fastening the Installation Brackets
(fig. 4)
• Each hob is provided with an installation kit including brackets and screws for fastening the
top to fixture panels from 2 to 4 cm thick.
• Turn the hob upside down and fasten the brackets “
A
” to the appropriate socket holes,
without tightening the screws “
B
” for the moment (fig. 5).
• Make sure that the brackets are fastened as shown in figure 4.
Fastening the Hob
(fig. 5)
• Spread the sealing material “ C ” out along the fixture hole, making sure that the junctions
overlap at the corners.
• Insert the hob into the hole and position it correctly.
• Adjust the position of the brackets “ A ” and tighten screws “ B ” to block the hob firmly in
position.
• With a sharp cutter or trimmer knife trim the excess sealing material around the edge of the
hob. Take care not to damage the benchtop.
A
A
A
A
A
A
C
B
A
Fig. 4
Fig. 5
20 mm min. 40 mm max.