12
Installation - fitting the extractor
Offer up the extractor to the cut-out/niche that you have prepared.
You may have to manoeuvre it slightly to get the extractor and hangar
hooks (A,B,C and D in Fig. 3) into the cut-out. With at least two others
supporting the extractor, tighten the screws that are accessible
through four holes on the downwards facing side of the extractor (Fig.
5) in roughly the same positions as A,B,C and D in Fig. 3.
A
B
C
D
Fig. 3
Fig. 4
Fig. 5
Please note:
This can be done without lowering the lid
