Tachograph programmer CD400 - User manual – V2.00 r07 (9/01/2014)
P I N c o d e
P r o t e c t i o n c o d e :
( * * * * )
PIN code
Conditions
not correct
P I N c o d e
Card 1
^
- 0 A M
P I N c o d e
P r o t e c t i o n c o d e :
( * * * * )
P I N c o d e
Card 1
#6
^
PIN code
PIN code sent
Check tacho.
P I N c o d e
#6 PIN:D00000
^
- 0 A M
PIN code
TCO already in
Calibration mode
4.10. PIN code
The "PIN code" function permits to send the workshop card PIN code to the tachograph automatically.
This function is available for the Digital tachographs (DTCO1381, SE5000 & EFAS)
Select the workshop card ID in the list (ie: name of owner) and press 'Ent'.
Press F1(MODIFY) to modify the data.
Press F3(Ok) to send the code.
MODIFY (card name, PIN code & protection code).
OK (send data).
Edit the card id.
Select the digit using the
'←' & '→' keys and set the
digit
value using the '↑' &
'↓' keys. Then press 'Ent'.
Enter the
protection code
and press 'Ent'
Adjust the PIN code length
using the '↑' and '↓' keys
and press 'Ent'.
Response 1.
PIN code has
been sent.
Check Tachograph.
Edit the PIN code.
Select the digit using the '←'
& '→' keys and set the digit
value using the '↑' & '↓'
keys. Then press 'Ent'.
Response 2.
The tachograph is
already in
calibration mode.
No PIN code required.
Enter a protection code
which will be required to be
able to send the PIN code.
The code can be from 1 to 4
digits long or can be left blank if not necessary.
Response 3.
The tachograph is
not ready to
receive the PIN
code (i.e. no card inserted).
PIN code
→
1.Card 1
2.Card 2
3.Card 3
4.Card 4
5.Card 5
P I N c o d e
Card 1
#6 PIN:******
M O D I F Y O K
Page
22
sur
23
