Tachograph programmer CD400 - User manual – V2.00 r07 (9/01/2014)
4.5. Odometer test
The programmer will automatically simulate a speed of 50km/h on 1000m distance and check if the
odometer as been incremented by 1000m.
For the K1314/1318 the K reference is set to the last K measured if
available, otherwize it is set to 8000.
For the other tachographs the K reference is set to the K factor
programmed in the tachograph.
If required, the K reference can be adjusted manually pressing 'F1'
(MODIFY).
KTCO1318/FTCO1319/EGK100
MTCO/VR2400/DIGITAL
Press 'F2' to adjust the position of the start point.
Press 'F3' (START) to start the test.
The inital value of the odometer (D1) will be read.
Press 'F3' (START) to start the test.
Wait until the progress bar is completed.
The test can be aborded pressing 'F3' (STOP).
Wait until the progress bar is completed.
The test can be aborded pressing 'F3' (STOP).
At the end of the test, the final odometer value will
be read (D2). The difference between D2 and D1 will
be calculated (D2-D1). If the difference equals
1000m, the test has been successful.
O d o m e t e r t e s t
K r e f = 0 8 0 0 0 p / k m
M O D I F Y O K
O d o m e t e r t e s t
1000
m
+ S T A R T
O d o m e t e r t e s t
0 1 0 0 0 m
S T O P
O d o m e t e r t e s t
D1:0041728740m
S T A R T
O d o m e t e r t e s t
D 1 : 0 0 4 1 7 2 8 7 4 0 m
S T O P
O d o m e t e r t e s t
D1:0041728740m
D2:0041729740m
( - ) 1 0 0 0 m
O K
Page
19
sur
23
