IP Video Intercom Waterproof Vandal-Resistant Door Bell Station ·User
Manual
24
pop up a message as below:
Figure 6-8 Reset to factory confirm box
Click “OK”, all the parameters (excluding IP address) will be reset to the factory
default settings.
If “Keep current IP unchanged” is unselected, the IP address will be reset to the
factory default settings.
There is time prompt in the web page during reset. After reset, it will skip to new
web page.
If current IP unchanged, you can access web page directly. If IP address resets to
192.168.1.18, you can’t access web page. Then, you have to set PC’s IP address
to 192.168.1 section, such as 192.168.1.25. After that, access web page to change
camera’s IP address and save, PC’s IP address will restore to the corresponding
section.
Note:
1. To avoid error happens, the operation of online reset function should be
performed under qualified personnel’s guide.
2. Default IP address is 192.168.1.18, and default subnet mask is 255.255.255.0.
3. Do not power off during reset, or else the reset will fail.
Online Reboot
Click “Reboot” button, the dialog box “This operation will take 100 seconds,are
you sure to continue？”pop up. Click “OK” and the system will restart.
There is time prompt in the web page during reboot. After reboot, it will skip
tonew web page.
