CB ELECTRONICS TMC-1, Setup Manual

Page: 9 / 14

9
3.
Use User Keys 3 "↑" and 7 "↓" to select the IP address for the MMP1 and press Key 2
"Select".
This will connect the TMC-1 to the MMP1.
You can check the TMC-1 IP address on the Network TCP/IP page by pressing User Key
4 "
→
".
If the TMC-1 has an IP address with a different subnet from the MMP1, pressing User Key
2 “Select” on the Discovery page will set a network address that has the same subnet as
the MMP1.
4.
Press the [Page] key to display the Meters page.
When the TMC-1 is connected to the MMP1, the text "No MMP1" at the top right corner of
the display changes to "TMC-1+MMP1".
To set IP addresses
The TMC-1 can be connected to a MMP1 using IP addresses obtained by either of the following
three methods: AUTO (link-local address), DHCP, and static IP.
If they are AUTO IP, devices will be connected to each other with the default settings and no
additional settings are needed.
MMP1 IP address
Set the IP address using DIP switches 7 and 8 on the rear panel of the MMP1. For details on how
to set an IP address, see the MMP1 Getting Started manual.