Cayken KCY-35QE, Operating Instruction

Page: 6 / 12

7
8
warrants this machine for a period of 6 months from the date of purchase
against defects due to faulty materials or workmanship and will repair without charge any
items returned. This warranty is void if the item has been damaged by accident or
unreasonable use, neglect, improper service, or other causes not arising out of defects in
materials or workmanship.
WARRANTY
1.Avoid body contact with grounded surfaces such as pipes, radiators, ranges and
refrigerators.
2.Don't expose power tools to rain or wet conditions. Water entering a power tool with
increase the risk of electric shock.
GROUNDING DEVICE
FAULT HANDING
Warning: magnetic drill equipped with a safety rope, when operating, make sure the
magnetic drill and the object is fastened by the rope.In case of power failure
suddenly, causing the machine fall off or thrown objects and cause accidents.
FAULTS
Magnetic base
without suction
Machine did not
run after the jump
Magnetic little
suction
Turn the handle gu
ide does not work
Drill out the
elliptical hole
Spindle sway
Motor strike
The frame adjusting screw is loose
The spark color turns orange red
Sparks fly out
Spark into a ring fire
Feedrate slow down
Please change the brush
Please check if the motor is burnt out
Tighten adjusting screw
Switch contact undesirable Repair the switch
Repair the power supply
Replace the Fuses
Repair or replace the magnetic bridge
Change the adsorption surface
Change the circuit board
Power supply is broken,Loose plug
The fuse burn out
Adsorption not on the steel frame
Circuit board burn out
Switch contact undesirable
Repair and change switch
Check the electric drill part connector
Repair or replace the electric brush
Changing the armature or stator
Joint loose
Adsorption artifacts thin
The adsorption surface is smaller than the
disk surface
Support bar between the adsorption surface
The diode circuit board may damage the
original weld.
Shaft key cut Replace the shaft key
Unscrew the rack bottom screw , remove guide to repair
Wheel and rack misplace
For a drill and a fastener is loose
Bit unilateral cutting
Adsorption surface have sundry
Eliminate clutter
Grind anew
Correction of verticality tighten the fasteners
Re Welding
Support bar top tight
Replace the adsorption surface or temporary welding
thick surface adsorption
Replace the adsorption surface or thickening adsorption surface
Brush and commutator poor contact
Drill the armature or stator coil burn out
Electromagnet short circuit or burn out
CAUSES ELIMINATION METHODS
Drill bit not concentric Change bit