Cayken KCY-320WEQ, Operating Instruction, Page: 8 / 16

6
APPLICABLE PROJECTS
The machine is applicable for cutting or slotting on armoured concrete, concrete brick wall,
stone material such as marble and wall.
MATTERS NEEDING ATTENTION
Check the following points before plugging in:
1.Use rated power supply
If the machine does not use rated power supply,it can not work.Please notice that only
the machine uses the right rated power supply and keeps the current in the control
cabinet at 6A,no more than 10A,the machine can work to its optimal efficiency and
without damage.
2.Make sure that the switch is in position“Off”
The switch on the control cabinet of the machine can be easily switched on.Make sure all
switches of the machine are off before plugging in to avoid the accident.
3.Make sure the blade is correctly fixed
Lock the blade screw in the clockwise direction.Fasten it with the open end wrench and
rotate the blade screw to see if it rubs with the blade guard.If it does,adjust the blade
and the blade guard before use.
OPERATING INSTRUCTIONS
A.Installation of the machine
Install the track way first,and then fix the machine on the track way.In order to cut the
wall surface flatly,the right method to install the track way is:The motor is on top and the
saw web in the downside.Keep the rotating direction of the saw web against that of the
running direction of the motor.In this case,it can not reduce the cutting time,but also
improve the cutting capacity.
1.Drill one anchoring spurs for the setscrew of 16.3-16.5mm in diameter and 55mm in
depth with the percussion drill at the position of133±2mm from the facet.It can hold a
machine with a M12 setscrew.The guide rail can be fixed in any place around the
anchoring spurs.
2.Use an air pressure gun to clean away the pieces in the anchoring spurs.
3.Drive in a machine with a M12 setscrew,insert a loosening bar into the screw hole,and
knock the fixed setscrew with a hammer.Make sure the setscrew is fixed tightly in the
holes,or else it may move or drop down in operation.Use the outfitted setscrew and screw
and so on to fasten the guide rail outfit.The number of the setscrew depends on the
softness of the cutting plane.The track way must be fixed tightly.