Alarm signal 2 (- - -) is a non life threatening
alarm, like a flooding alarm:
Smoke alarm signal: --- --- ---
Heat alarm signal: --- --- ---
Flood alarm signal: - - -
Please note that only the originating alarm’s LED
will flash, so it can be identified.
9. PAUSE/HUSH FUNCTION:
If the smoke alarms are to set into a false alarm
by cooking, fireplace, etc. they can be paused for
10 minutes by pressing the test button on the
originating smoke alarm only (indicated by the
flashing LED).
The reason of this is that it is necessary to locate
the source of the alarm before using the hush
function. This is to make sure that it is not a life
threatening situation.
10. ADD EXTRA DEVICE:
All CAVIUS interconnected alarms within the
can be added to the system as
they run on the same frequency and use the same
data protocol.This means that the wireless system
can consist of a combination of smoke, heat, flood
etc.
Place all alarms into ‘Learn Mode’ and repeat
section 1.
Always test connection to all devices by repeating
test function section 6 after adding devices.
11. LOW BATTERY SIGNAL:
Your product has a 5Y battery life.
When the battery is starting its end of life, a short
beep will sound out every 48 seconds for 30 days.
The alarm affected by the low battery will only
beep, no other connected alarms will sound.
It is safe to change batteries in the alarms without
going through the learn process again – they will
not forget the codes during the battery change
process.
12. BATTERY REPLACEMENT:
To replace the battery, detach the smoke alarm
from the mounting base by twisting counterclockwise.
Replace the battery respecting the polarities.
Caution: There is a risk of explosion if the batteries
are replaced by an incorrect type.
Attach the alarm in the mounting base by twisting
clockwise until it clicks, and test the alarm.
13. MAINTENANCE & TROUBLE SHOOTING:
• The smoke alarm should be vacuum cleaned
once per quarter, to remove dust particles, and
it can be wiped with a damp cloth. (Do not open
the alarm).
• High humidity condensing which can be
resolved by drying the smoke alarm.
If the smoke alarm does not work when the test
button is pushed, the probable cause is a faulty
battery. Check if the battery is worn out and re-
place it. Always test the alarm after replace-
ment of battery.
If the problem continues, please visit www.cavius.
com for any trouble shooting.
14. OTHER INFORMATION:
Do not paint the alarm.
Disposal: For battery and product, please dispose
properly at the end of life. This is electronic waste
which should be recycled.
Please note local regulations about information
to your insurance company regarding installed
smoke alarms.
Complies to the Radio Equipment Directive
2014/53/EU
RF Frequency: 868 MHz.
Maximum radio-frequency power transmitted: 20
dBm.
Full DoC to 2014/53/EU (RED) can be download-
ed at www.cavius.com.
WARNING: All alarms should be assumed as due
to actual fire and the dwelling should be evacuat-
ed immediately.
WARNING: To prevent injury, this apparatus must
be permanently fixed to the ceiling/wall in accor-
dance with the installation instructions.
WARNING: Batteries shall not be exposed to ex-
cessive heat such as shine, fire, or the like. Note
the local country regulations regarding installa-
tion.
The CE mark affixed to the product confirms
compliance with all relevant European directives
and harmonized requirements in the EN14604
standard and Construction Products Regulation
(CPR) 305/2011 along with the Radio Equipment
Directive (RED) 2014/53/EU for all wireless family
products.
All Rights reserved: CAVIUS assumes no responsi-
bility for any errors, which may appear in this manu-
al. Furthermore, CAVIUS reserves the right to alter
the hardware, software, and/or specifications de-
tailed herein at any time without notice, and CAVI-
US does not make any commitment to update the
infor mation contained herein.
Developed by CAVIUS
Jens Juuls Vej 28 K, DK-8260
Manufactured in P.R.C.
Once the mounting base is installed, attach the
alarm by twisting clockwise until it clicks. If the bat-
tery is either missing or inserted incorrectly, or the
switch is in ‘Learn Mode’, the smoke alarm will not
be able to click into the mounting base.
6. TEST FUNCTION:
After installation, and at least once per quarter,
test all of your alarms to ensure they are operating
correctly and are within range of each other.
It is recommended to check visually every week if
the LED flashes correctly (every 48sec.)
Press the test button on any alarm for at least 10
seconds. This will send out a test signal from the
alarm; all other connected alarms should receive
the signal within a short time. The alarms will
emit a short beep and the LED will flash every 8
seconds for 2 minutes.
NOTE: Test function also allows to send a deplet-
ed RF signal to ensure an optimal operation in
normal conditions.
When the test signal is sent out, the alarms will
respond in two ways:
1. A single beep every 8 seconds indicates that the
alarms are connected and functioning.
2. Three short beeps every 8 seconds indicates a
smoke sensor fault. The alarm should be cleaned
by running the vacuum (on a low setting) around
the smoke alarm chamber and tested again.
If required this indication can be stopped early on
each alarm by a short press of the test button.
TIP: It is safe to cover the sound output hole with
your finger during the testing to minimize the
sound level emitted.
If the problem continues, please visit www.cavius.
com for any trouble shooting.
7. NORMAL MODE:
In normal mode the LED will flash every 48 seconds
to show correct operation.
8. ALARM MODE:
When a concentration of smoke is detected, the
smoke alarm will go into ‘Alarm Mode’. It will
sound the alarm signal and the LED will flash.
The smoke alarm will also transmit the alarm sig-
nal to the other connected alarms, which will also
sound the alarm signal after a short delay.
The CAVIUS Wireless Family have two different
alarm signals:
Alarm signal 1 (--- --- ---) is life threatening
alarms, like a smoke alarm.
CLICK THE SMOKE
ALARM FIRMLY INTO THE
BASE TO LOCK
127786 rev12
EN 14604:2005 + AC :2008
DoP no.: 2103
1116
21
The CE and RED declaration of conformity and DoP can be downloaded from: http//www.cavius.com
The paper version of the DoP is available free of charge upon request.
Declared performance 4.1-4.19 + 5.2-5.24: Passed.
©2022 Carrier. All Rights Reserved.
All trademarks and service marks referred herein are property of their respective owners.
