Cattani ASPI-JET 6 y, Operator'S Handbook Manual

Page: 11 / 24

3C 2
12
15
11
cod: ed. 10-2021
EN
G
LI
SH
INSTALLATION
INSTALLATION
The aspirator must be installed in compliance with
CEI 62-5 regulation for electro-medical appliances
(Aspi-Jet 6-7-8-9 γ have been designed accordingly).
Prior to plugging in the unit, check the specifications
on the label and make sure that the mains are
compatible with the appliance and protected against
overcurrent according to CEI 64/8 regulations.
The appliance must be protected against indirect
contacts for class I appliances according to CEI 64-8
reg. and 64-4 for rooms used as medical consulting
rooms (IEC correspondents available on demands).
The plug and cable are equipped with earthing
protection: do not remove this protection in any
case and make sure that the socket is compatible.
Once installation has been completed, the unit
can be switched on by pressing the main switch
1 located on the front panel; the switch will light
up and aspiration will start by lifting one of the
terminals from its seat. If you open the cabinet
door the electrical circuit is open and the aspirator
stops. In standard assembled units aspirated air is
exhausted through the silencer (2) (Fig. A). In order
to convey exhausted air outside you need to fit an
extension to hose 3C and drive it outside (Fig. A).
Most of the noise and bacteria will be carried
outside together with air; we can also supply a
certified bacterial filter for exhausted air.
When installing Aspi-Jet 8 γ and 9 γ , besides all
general directions and regulations mentioned, the
engineers shall:
- connect the water supply, without removing the
antispray tube 15 (Fig. B), which protects the Rilsan
tube against bursting;
- check any possible leaking, especially near parts
subject to tension;
- adjust water pressure to a max of 4 bar by using
the pressure control device 12 (Fig. B).
Fig. A
Fig. B