Catler BM 8010, Instructions For Use Manual

Page: 17 / 28

17
OPERATING YOUR BEVERAGE&TEA MAKER BM 8010
8. Press the appropriate button to choose
the optimal temperature for preparing
the elected type of tea. The relevant
button lights up white when it is pressed.
The START/STOP button also glows
white. To start the water heating to the
set temperature, press the START/STOP
button. The control light of the START/
STOP button glows red.
9. As soon as the water gets to the desired
temperature, 5 beeps sound to indicate
the temperature has been reached.
NOTE:
If you remove the water kettle from
the stand while it is heating water,
heating automatically stops and
the panel automatically switches to
“Ready”.
“KEEP TEMPERATURE” MODE
•
After the water has been heated,
the kettle automatically switches to
“Keep Temperature” mode. In this
mode, the kettle maintains the set
water temperature for no more than
10 minutes. The button for setting
water temperature blinks white, and
the START/STOP button still glows
red. During this time, it is necessary to
prepare the tea for brewing and switch
the kettle to brewing mode.
•
Grasp the handle on the internal lid and
turn the lid counter-clockwise, so that
the arrow shown on the internal lid is
even with the open lock symbol on the
outside of lid. Carefully remove the lid.
Be sure not to get scalded by the steam
that can escape from the slot in the lid.
Prepare the tea strainer and put the
proper amount of tea into it. Grasp the
tea strainer by the handle, and insert it
into the slot in the external lid. The edge
of the strainer must click into the slot all
around the external lid. The handle of
the strainer must be placed above the
handle, which is used for carrying the
kettle. Close the slot in the external lid
using the internal lid.
NOTE:
If the water kettle is removed from
the stand during “Keep Temperature”
mode, the mode automatically ends,
and the control panel switches to
“Ready” mode.
Two minutes after “Keep Temperature”
mode automatically starts, 5 beeps
sound to remind you that the kettle
has not yet been switched to brewing
mode.
If you have not launched brewing
mode 10 minutes after “Keep
Temperature” mode automatically
launches, switch to “Standby” mode.
To save energy, all the button lights go
off. From “Standby” mode, switch the
kettle into “Ready” mode by pressing
any button, removing the kettle from
the stand or unplugging the stand and
then plugging it back in.
TEA BREWING MODE
•
Press the same button (blinking button)
that you previously used to set the
temperature, to switch the kettle to
brewing mode. The brewing times for
each temperature setting button are
preset as follows.