Catler BM 8010, Instructions For Use Manual

Page: 15 / 28

15
OPERATING YOUR BEVERAGE&TEA MAKER BM 8010
PURPOSE OF WATER KETTLE
This kettle not only boils water, but also
makes tea preparation easier thanks to its
adjustable temperature. Just choose the
optimal temperature for the selected type of
tea, and let the water heat up. After heating
the water, put tea in the tea strainer, put the
tea strainer in the kettle, and start brewing
mode. Then just wait for the acoustic signal
that tells you brewing time is finished and
time to take the strainer with the steeped tea
out of the kettle. The automatic “Keep Warm”
function keeps the tea hot for 30 minutes.
BEFORE FIRST USE
1. Take the water kettle and all accessories
out of the packaging.
2. Grasp the internal lid by the handle and
turn it anticlockwise until the arrow
symbol on the internal lid is even with
the open lock symbol shown on the
outer lid. Take off the lid and set it aside.
Remove the tea strainer from the kettle
and then remove the outer lid. Wash
out the internal lid, external lid and tea
strainer under hot running water with
neutral kitchen detergent added. Then
thoroughly rinse out these parts under
clean, hot running water and towel dry.
3. Fill the water kettle with clean tap water
to the maximum mark (1.2 l). Make sure
that the water level does not exceed the
maximum mark.
WARNING:
Do not fill the kettle
with water when it is
on the stand.
4. Put the external lid onto the water kettle,
and press it down, so that it settles over
the entire circumference to the kettle’s
neck. Into the center of the cover lid
insert the internal lid so that the arrow
symbol on the internal lid is even with
the open lock symbol on the outer lid.
Grasp the internal lid by the handle and
turn it clockwise until the arrow symbol
on the internal lid is even with the closed
lock symbol. Now the kettle is properly
closed.
NOTE:
When preparing the kettle for first use,
it is not necessary to insert the tea
strainer.
2. From the bottom of the stand, unwind
the necessary length of power cable.
Pull the power cable through one of the
three slots in the base. Put the stand on
an even, dry, stable surface and plug the
power cable in.
6. Put the water kettle, which you have
previously filled with water, onto the
stand. Press the Boil button. The light-up
control buttons Boil and START/STOP
glow white. To start the boiling process,
press the START/STOP button. The control
light of the START/STOP button glows
red, and the water starts to heat. As soon
as the water boils, 5 beeps sound. Once
the water boils, the kettle automatically
switches to “Keep Warm” mode. To end
this mode, press and hold the START/
STOP for about 2 seconds. Then a long
beep sounds to confirm that “Keep
OPERATING YOUR BEVERAGE&TEA MAKER BM 8010