Cateye GAMEBIKE FITNESS PRO GB-300R, Operation Manual

Page: 6 / 24

ENG
6
ANALOG
SELECT START
STEERING LEVEL SPEED LEVEL
R L
STEERING LEVEL
ANALOG
SELECT START
STEERING LEVEL SPEED LEVEL
R L
SPEED LEVEL
“Playstation2” unit
To GBF PRO RECUMBENT BIKE Controller
Controller connector
1P side
2P side
Controller cover
Controller
Min. Max.
Speed sensitivity
Slow
Fast
Steering sensitivity
Connecting the device to Playstation2
This controller is compatible with the “Playstation2”. Plug the connector of this device into the controller terminal located at the front of the
“Playstation2”. Consult the operating manual of the “Playstation2” unit, if necessary.
Important: If the GBF PRO RECUMBENT BIKE does
not operate after connecting it to the
PlayStation2 unit, disconnect it and
reconnect it again.
Reference: It is possible for two players to play
simultaneously by connecting two GBF
PRO RECUMBENT BIKEs or connecting
to a general controller.
FCC
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Controller Cover Care
While using GBF PRO RECUMBENT BIKE, the user may perspire/sweat while
training.
To prevent sweat from getting into the controller, please use
the controller cover provided.
Please wash and dry after use.
Button Function change
In the case of software with different button functions, change functions as follows:
The buttons to which functions can be assigned are green, pink, red, blue, L1, L2, R1 and R2.
<Operation>
Keep pressing the SELECT button until the following steps are completed:
1.Press the blue (or pink) button depending on the function to be changed.
The LED will change from constantly lit to blinking.
2.Press the default accelerator (or brake) button in the software currently being used.
The LED will change stop blinking and will be lit continuously, signifying that the function change is now complete.
(If analog mode is OFF, the LED will be off, signifying that the function change has been completed.)
• Revert to the original button function
While pressing the SELECT button, press the speed button (blue) or brake button (pink).
How to adjust the Controller
• Adjusting the speed sensitivity
Turn on the “Playstation2”. Slide the controller’s speed sensitivity level
control and check the GBF PRO RECUMBENT BIKE pedals on the Race
Screen. Adjust the speed sensitivity to a suitable level.
Caution Depending on the software, while pedaling, the speed
of the game does not register.
This will cause the game not to move forward.
• Adjusting the steering sensitivity
Turn on the “Playstation2”. Slide the controller’s steering sensitivity level
control and check the operation of the GBF PRO RECUMBENT BIKE steer-
ing on the Race Screen. Adjust the steering sensitivity to a suitable level.
Caution Depending on the software, if the steering sensitivity is
set to Min. when the steering is turned from left to
right, the steering reaction does not work for the game.