CaterChef 688.130, Operation Instructions Manual

Page: 22 / 26

688130 nl-en ma 2016
22
En
note: The foam gaskets around the vacuum chamber should be dried thoroughly before re-assembling,
when re-assembling, is careful to prevent any damage, and assemble as original position to ensure no
vacuum leaking.
Vacuum bags
1. Wash bags in warm water with a mild dishwashing soap
2. When wash bags in dishwasher, turn bags inside out and spread them over top rack of dishwasher,
so entire surface is exposed to the washing water.
3. Dry thoroughly before reusing.
IMPORTAnT:
To avoid possible illness, do not reuse bags after storing raw meats, raw fish or greasy
foods. Do not reuse bags that have been microwaved or boiled.
Accessories
Washing all vacuum accessories in warm water with a mild dishwashing soap, but do not immerse cover in
water.
1. Canister bases (not lids) are top rack dishwasher safe.
But canister cover should be wiping down with a damp cloth.
2. Ensure the accessories to be dry thoroughly before reusing.
3. Canister and cover is not allowed to use in microwave or freezer.
Storing Your Vacuum Sealer:
1. Keep the unit in a flat and safe place, out of the reach of children.
2. Do remember to make sure the lid of appliance is unlocked when not in use and in storage.
Keep the cover locked will distort the foam gaskets causing leaking.
MAInTEnAnCE KIT InSTRUCTIOnS
Replacing the gasket:
1. Turn “
O
” the switch and remove the Power Cord from the electrical outlet.
2. Make sure the unit is completely cool.
3. Open the Acrylic Vacuum Lid.
4. Remove the gasket from the groove on the underside of the Acrylic Vacuum Lid.
5. Remove the gasket from the groove in the Plastic Vacuum Chamber.
6. Set a new gasket on the groove in the Plastic Vacuum Chamber.
Work the seal into the groove with your fingers until done.
7. Position a new gasket into the groove in the Acrylic Vacuum Lid.
Work the seal into the groove with your fingers until done.
Replacing the Teflon tape:
1. Turn “
O
” the switch and remove the Power Cord from the electrical outlet.
2. Make sure the unit is completely cool.
3. Open the Acrylic Vacuum Lid.
4. Pick at either end of the Teflon Tape covering the Seal Bar Heating Element with a fingernail or
sharp-edged tool until it lifts slightly. Grasp the loose end and slowly pull the Teflon Tape back over itself
until fully removed.
5. Remove the backing from a new wide strip of Teflon Tape for the Seal Bar Heating Element. Be careful
not to allow the Teflon Tape to contact anything including itself while the adhesive side is exposed.
6. Hold one end of the Teflon Tape in each hand. Stick the left end of the Teflon Tape to the flat area on
the Plastic Vacuum Chamber just left of the Seal Bar Heating Element. Apply the Teflon Tape from left
to right over the Seal Bar Heating Element until done. Make sure there are no wrinkles or folds in the
Teflon Tape once applied. The Teflon Tape should fully cover the Seal Bar Heating Element.