4
Regulatory Notices
USA
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
⚫
Reorient or relocate the receiving antenna.
⚫
Increase the separation between the equipment and receiver.
⚫
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
⚫
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and must not be co-located or operating in conjunction with any other antenna or
transmitter.
For body worn operation, this device has been tested and meets FCC RF exposure guidelines. When
used with an accessory that contains metal may not ensure compliance with FCC RF exposure
guidelines.
Canada
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada’s licence
-exempt RSSs. Operation is subject to the following
two conditions:
(1)
This device may not cause interference; and
(2)
This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
