INSTALLING THE PURE AIR PURIFIER
Unpacking the Purifier
NOTE: Before unpacking the product, inspect the shipping container for vis-
ible damage. If you feel that you may have received the product in a damage
condition, notify the shipper or supplier before opening the container. Remove
the product from the box and inspect it for damage. Handle it carefully. Do not
drop it!
Installing the Purifier
Place the purifier in a location that will NOT restrict the inlet air flow towards
the front or sides of the unit front grill or the outlet air flow from the top grill.
The outlet air flow pathway which allows the unit to be most beneficial in-
cludes an unobstructed flow towards the room ceiling. Once the unit has been
positioned, plug-in the electrical cord at the nearest electrical wall outlet.
Installing the Purifier
1. Press-in Power ON/OFF button to turn-on the Purifier. Lights on the control
panel (figure 1) will turn on and the ultraviolet lamp will be “On”.
2. Look into the air outlet at the top of the Pure Air Purifier and confirm that the
ultraviolet lamp is operating. You will see a faint blue glow when the lamp is
on. If the lamp appears to be “Off”, refer to “Maintaining the Pure Air Purifier.
When the lamp is “On”, the product is ready for operation.
CAUTION
This product is for indoor use only.
Figure 1
Replacing Filters
When the Yellow Filter indicator lights, filter should be replaced within 30 days.
Here’s the step-by-step procedure:
1. Unplug the Purifier’s
power cord from the
electrical outlet.
2. Rest the Purifier on its
back (figure 8) to access
the bottom of the unit.
3. Press-in locking clip at
each end of the front grill.
4. Lift the bottom of the front grill away
from the locking clips, approximately
1”, (figure 9) and slide the top of the
front grill towards the unit’s feet to
free the front grill tabs that are in
serted into the unit housing under the
control panel. Set the front grill to the
side and vacuum any collected dirt
and debris attached to the inner grill
areas before reinstalling
5. Pull out the two filters, individually, and discard them.
6. Install the new HEPA filter in the lower slot with the white pleated
layer facing upwards and the sealing gasket on the downward side.
When correctly in place the words “SECOND-STAGE” and “FRONT
SIDE” printed on the replacement filter are clearly visible.
Figure 9
Figure 8
Locking Clips
-page 3-
-page 8-
Motion Sensor
Chemical Sensor
