Catalyst Machineworks 210-R, User Manual

Page: 29 / 31

• My quad flips over when I try to take off.
• Possible Solution: Verify the props are installed correctly.
• My quad will power up but the motors will not arm.
• Possible Solutions: Three things must happen before the motors will arm.
1) The throttle must be at zero stick (all the way down).
2) The quad must be completely motionless while the flight controller boots up just after power is applied.
3) Any warning must be cleared from the transmitter by hitting the “exit” button just after you turn on the
transmitter.
• My FPV camera feed seems out of focus.
• Possible Solution: The FPV camera has a removable lense that we pre-focus for you. But, it is possible the lense can
move due to vibration or crashes. To refocus the FPV camera you simply loosen the retaining ring then turn the
lense to refocus the camera.
• My HD camera footage has jello in it!
• Possible Solutions:
1)
HD camera are very sensitive to vibration. Even the slightest bit of vibration will show up in your footage. For this
reason it is imperative you pay attention to the condition of your props. Even a prop that has a small nick, dent, or
bend may result in a degradation of your footage. Replace damaged props for the best possible HD camera
footage. Do not use low quality props or your HD footage may suffer!