41
OPERATION
Electronic programmer
functions
MENU
– function selection button
<
- sensor “–”
>
- sensor “+”
Setting the time
After connection to the mains or reconnec-
tion after a power cut the display shows flash
Timer
The timer can be activated at any time, re-
gardless of the status of other functions. The
timer can be set for from 1 minute to up to 23
hours and 59 minutes.
To set the timer you should:
l
Press sensor
MENU
, then the display will
show flashing
,
0
0 00
0
0 00
l
set the timer using sensors
>
and
<
.
The time set is shown on the display and the
signal function is on.
l
Press sensor
MENU ,
<
or
>
in order to
switch off the signal, the signal function will go
out and the display will show the current time.
Caution!
If the alarm signal is not turned off manually,
it will be turned off automatically after approx.
7 minutes.
l
Touch and hold
MENU
(or simultaneously
touch
<
and
>
) until you will see on the
display and the dot below the symbol is
flashing,
l
Touch
<
or
>
within 7 seconds to set the
current time.
To store the new time setting, wait approxi-
mately 7 seconds after time has been set.
The dot below the
symbol will stop flashing.
You can adjust the time later. To do this touch
<
and
>,
simultaneously and adjust the cur-
rent time while the dot below the symbol
is flashing.
Caution!
If the correct time is not set then proper opera-
tion of the oven is not possible.
