EURO User Manual
Warning Indications
Page 5
All setting points (Keypads or Tag Readers) have
LEDs to clearly indicate what is happening.
The
‘Alert’
LED will flash if there is information
available to you. Enter your code to see the
information. After a code has been entered, one
of the following LEDs will light: Alarm, tamper or
fault. The relevant detail of the problem will be
shown on the display. To clear the display, press
the ‘Yes’ key (or the display will clear
automatically after 3 minutes.)
The
‘Alarm’
LED will flash after code entry if an
alarm occurs.
The
‘Tamper’
LED will flash after code entry if
the wiring or equipment is tampered with.
The
‘Fault’
LED will light after code entry to
indicate if a technical fault occurs.
The
‘Unset’
LED will light for 5 seconds if the
panel is completely Unset (steady) or if some
areas remain Set (flashing). It will also illuminate
during the setting procedure, turning off once
set.
Alert Alarm Tamper Fault Unset
