16
A
TTACHING
T
HE
M
ICROPHONE
TO
THE
MW401
W
INDSHIELD
Step 3
Carefully push the pre-amplifier through the MW401 pre-amplifier clamp until
the de-humidifier and 10mm of the pre-amplifier are visible. Now tighten the
clamp into place using the allen key provided with your kit.
Step 4
Attach the microphone capsule over the de-humidifier unit and then place the
MW401 rain guard over the pre-amplifier assembly. Fasten using the supplied
allen key.
Step 5
Attach the windshield holder over the assembly and fasten using the allen key,
now place the windshield into position. Finally pull the extension cable through
the slot in the stem and screw the tripod adaptor into place.
The KA018 uses two sealed 12V, 17 Ampere Hour, rechargeable lead acid
batteries. Only use the batteries supplied by Castle and always ensure if
replaced that they are inserted with the terminals to the top. For safety
precautions never operate the KA018 kit upside down.
For safe charging of the batteries the following points must be adhered to:
•
Only charge indoors
•
Never close the KA018 case lid whilst charging
•
Use only the supplied charging unit
To charge the case batteries, firstly ensure the above criteria are met. Ensure
the Battery Disconnect Switch is ON (indicating Blue) and insert the charging
plug into the control box socket labelled “Charge”. Charging both batteries
completely, if depleted may take approximately 14 Hours. When your charger
unit illuminates Green then charging is complete. (Refer to the charger manual
for more detail if required).
The KA018 kit can only be powered from the external battery pack or external
power supply connector whilst the batteries are being charged.
To reduce the weight of the KA018 the kit may be powered using one battery
only, however this may cause an unbalance when carrying the case. The
operational time will also reduce by approximately one half.
Operational life of the batteries, on continuous use, will be approximately 6 days.
This time will vary depending on whether the case printer and DAT are used
during operation, and also on the initial battery charge. Extensive use of either
the printer or DAT machine will reduce the time the KA018 Kit will operate for,
however the batteries may be removed and replaced whilst the KA018 is
running and is recommended for long running applications.
To replace the batteries, perform the following procedure:
♦
Unplug and remove the left side battery
♦
Replace and connect the charged left side battery
♦
Unplug and remove the right side battery
♦
Replace and connect the charged right side battery
5
B
ATTERIES
A
LL
B
ATTERY
R
EMOVAL
A
LL
