OPERATION
TS--2700/TS--3300 (05--04)
6
MACHINE INSTALLATION
UNCRATING MACHINE
Carefully check carton for signs of damage. Report
damages to carrier at once. Check carton contents to
ensure all accessories are included. Squeegee is
packaged with machine. Batteries, battery charger and
pad drivers are packaged separately.
To uncrate your machine, remove shipping straps and
raise scrub head. To raise scrub head, step down
firmly on the bottom brush lift foot pedal until pedal
locks into the raised position. Carefully lift or use a
ramp to remove machine from pallet.
ATTENTION: Battery installation must be
accomplished after removing machine from
shipping crate.
ATTENTION: Do not roll machine off pallet,
machine damage may occur.
ATTACHING SQUEEGEE ASSEMBLY
1. Slide squeegee lift lever to the right to raise
squeegee mount bracket (Figure 1).
FIG. 1
2. Loosen two thumb knobs on squeegee and slide
squeegee into slots at rear of squeegee mount
bracket. Be certain that squeegee roller wheels
are toward the rear (Figure 2).
FIG. 2
3. Tighten thumb knobs securely.
INSTALLING BATTERIES
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and safety glasses when
handling batteries or battery cables. Avoid contact
with battery acid.
Recommended Battery Specifications:
Four 6 volt, deep cycle, 305 amp hour batteries. Part
Number 606991. Maximum battery dimensions are
178mm (7 in.) W x 308mm (12.13 in.) L x 356mm
(14in.) H.
1. Turn all switches to the off (O) position.
2. Carefully hinge open recovery tank to access
battery compartment. Remove loose battery
cables from compartment (Figure 3).
FIG. 3
