8
1) Vehicle stops in the service position with engine off
2) Turn the handle for hydraulic movable wheel to lift the vertical post base a bit
3) Push the lift into the underside of vehicle
4) Make sure there is no foreign articles under the base and the ground is level
5) Grasp the valve handle to make the base lowered to ground
6) Align 4 pallets on the lifting arm respectively to the supported positions on the vehicle
underside
7)
Press the “green” button to raise the vehicle by 10
～
15 centimeters
8) Stop the vehicle raising and check for safe and secure four high points of the pallet.
9) Check if the main lifting arm touches the vehicle bottom plate, which should not occur
during normal lifting.
10) Pull the safety unlock handle to make the fliting platform unlocked.
11) To adjust lifting pad, turn it anticlockwise to make it rise ( adjustment distance of
100mm)
12)
Press the “green” button again and pay attention to lifting arm and the vehicle lifted
until lifting is safe and reliable.
13) Raise the lift to the required height, then lower it to the lock position
14) After the repair of vehicle is finished, raise the lift about 2-3cm, pull the release calbe
on the column, then push the lowering handle on power unit to lower the lift.
15) Turn the handle of hydraulic pump and the lift is off the ground, pull out the lift.
16) Drive the vehicle away.
