Cassese CS 88, Technical And User Manual

Page: 7 / 17

SETTINGS
4
USE OF THE 2 SELF-ADJUSTING BACKFENCES
Position a moulding against the LEFT
backfence.
Loosen the locking knob B.
Press the moulding against the table T,
tilt the backfence so that it fits behind
the moulding, then tighten knob B.
Position the second moulding on the
RIGHT backfence and repeat the
operation.
B
T
As a general rule a MINIMUM 2 mm clearance (less than 1/8”) above the wedges shall be
respected.
Same sized wedges can be stacked
in order to avoid to have to change the cartridge size when
joining frames with different thickness.
AS A GENERAL RULE, THE JOINING MUST BE CARRIED OUT AS
CLOSE TO THE THICKEST MOULDING PART(S) AS POSSIBLE .
SELECTION OF STAPLING POSITIONS
The CS 88 / 89 is designed to join mouldings in one or two places (positions) without limitation
of the number of wedges in any of those places. The selection depends on the width and thick-
ness of the moulding to join.
2 mm MINIMUM
2 mm MINIMUM
(Approx.1/8’’)
(Approx.1/8’’)