16
Removing and Cleaning the Purification Plate
1.
Follow the instructions for removing the Rear Cover and
Filter Assembly on Page 12.
2.
Grasp the Purification Plate on the ceramic surface and
gently pull it out of the grooves on the sides.
3.
Using a 50/50 mix of warm water and clear ammonia, or in
place of the water and ammonia mixture use 100% white
vinegar, soak the Purification Plate for 8 to 10 hours. Do
not exceed 10 hours. Using a soft bristled tooth brush,
scrub the wire mesh to remove debris lodged inside the
mesh. Rinse thoroughly. Allow the Purification Plate to dry
completely before reinstalling.
4.
Use a soft cloth and rubbing alcohol to clean the metal
contacts that touch the Purification Plate.
5.
Holding the Purification Plate by the ceramic, align it with
the grooves on either side and slowly insert it into the
Purification Plate Slot.
The Purification Plate Generates an Electrical Arc, an
Arcing Noise or a Burning Odor
This means the Purification Plate is damaged and must be
replaced. The unit may or may not display the Replace Plate
LCD reminder. To order a replacement, contact your
distributor or
Airande
(
www.airande.global
).
The Cell Does Not Light Up
Ensure the Cell Power Connector is properly seated in the
Cell
Power Connector Outlet.
1.
Follow the instructions for removing the Rear Cover
and Filter Assembly on Page 12.
2.
Check to see if the Cell Power Connector is properly
inserted in the Cell Power Connector Outlet. To ensure
the proper connection, gently push until the tabs at
the top and bottom of the Cell Power Connector snap
into place, securing it to the Cell Power Connector
Outlet.
3.
If the Cell still fails to operate, it needs to be replaced.
Contact your distributor or
Airande
(
www.
airande.global
).
WHEN CHANGING THE BULB
1. read the maintenance Instructions BEFORE opening the Appliance
2. The Appliance MUST be DISCONNECTED FROM THE SUPPLY
before replacing the bulb (I.e., the UV-C emitter)
3. Take the following precautions when replacing the bulb (UV-C
emitter):
a. DO NOT operate the bulb (UV-C emitter) outside of the
Appliance
b. Make sure that the Appliance is fully reassembled with the
new bulb (UV-C emitter) securely in place
c. DO NOT reconnect to the power supply until the Appliance
has been fully reassembled
