43
12.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces
the quantities of accumulated waste. Take any packaging materials that are no
longer required to “Green Dot” recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.
► Blowing gas inside the unit is flammable. The disposal of this flammable material should
be in accordance with national regulations.
12.5 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
Place your device on a flat, horizontal floor that is strong enough to support the device
when it is fully loaded.
Locate the device away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption.
This device is not designed for use in a garage or any other outside installation.
Warning: Fire hazard due to moisture!
► If live parts or the power cord get wet, this can lead to short circuits.
► The device is intended for use in closed rooms. Do not operate the device outdoors or in
areas where it is exposed to splashing water or moisture.
Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
WARNING! Do not close the ventilation openings in the device housing (and installation
housing). When installing the device, leave openings for ventilation.
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
For energy saving reasons please ensure that the door is closed when the device is
turned on.
Summary of Contents for 7710
