•
Place your appliance on a floor that is strong enough to support the appliance
when it is fully loaded.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
•
Ambient temperature below 16°C or above 38°C will hinder the performance of
the appliance.
•
This unit is not designed for use in a garage or any other outside installation.
•
Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
•
The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 45 cm around the appliance.
•
Do not cover up any openings on the device and do not block these off.
•
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup locations (e.g.
on ships) must be carried out by specialist companies / electricians, provided
they guarantee the prerequisites for the safe use of this
device.
•
For energy saving reasons please ensure that the
drawers are closed when the appliance is turned on.
•
Adjust the adjustable feet, so that the device is placed
even.
3.6 Electrical connection
In order to ensure the safe and trouble-free operation of
the device, the following instructions must be observed for
the electrical connection:
•
Before connecting the device, compare the connection data (voltage and
frequency) on the rating plate with those of your electrical network. This data
must agree in order that no damages occur in the device. If in doubt, ask your
qualified electrician.
•
The electrical outlet must be protected by a 16A safety cut-out switch.
•
Do not bend the power cord. Make sure that the power cable is undamaged and
has not been installed under or over hot or sharp surfaces.
•
The connection between the device and the electrical network may employ a 3
meter long (max.) extension cable with a cross-section of 1.5 mm². The use of
multiple plugs or gangs is prohibited because of the danger of fire that is involved
with this.
