CASO DESIGN Sound & Cool 790, Operating Manual

Page: 38 / 146

38

Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.

The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 45 cm around the appliance.

Do not close the ventilation openings in the device housing.

The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.

The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies /
electricians, provided they guarantee the prerequisites for the
safe use of this device.

For energy saving reasons please ensure that the drawers are
closed when the appliance is turned on.

Adjust the adjustable feet, so that the device is placed even.
12.6 Electrical connection
In order to ensure the safe and trouble-free operation of the
device, the following instructions must be observed for the electrical connection:

Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.

Do not bend the power cord. Place the power cord in a way so that you do not trip over it.
Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.

The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.

This unit is not designed to be installed in an RV or used with an inverter.

The electrical outlet must be protected by a 16A safety cut-out switch.

The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
for damages that are caused by a missing or damaged protective conductor.
Options to connect the power cord:
In case you have a ground socket below the device use this to plug in.
Alternatively you can use a wall socket. In this case make sure that the
power cord is placed carefully to avoid stumble, by placing under a carpet or
by using the included cable channel (K).
Danger
► The mains plug must be plugged firmly into the connection socket on the bottom of the
device, otherwise there is a risk of fire.