1.
Undo the front
cover screw and
remove the cover
of the accessory
drive shaft.
2.
Insert the auger
(4) into the auger housing (3).
3.
Place the blade (5) in front
of the auger so that the flat
sides face the perforated
disc. The blade is sharp, so
be careful with it.
4.
Place the desired perforated disc (6)
in front of the blade paying atten-
tion to the two recesses (left/right)
of the auger housing.
5.
Put on the
fastening ring
/ cover nut (7)
and tighten it
clockwise.
6.
Place the min-
cer attachment
on the drive
shaft and tighten
the screw.
7.
Place the feed tray
(2) on the auger
housing.
Assembling the mincer
1.
Cut the desired ingredients into pieces that
fit into the feed chute.
2.
Check that the mincer is firmly mounted on
the motor head.
3.
Put the ingredients into the feed chute and
the filling tray.
4.
Place a container under the outlet.
5.
Plug the power plug into the outlet.
6.
Tap the button and select a speed level.
We recommend speed level 3–5.
7.
Start the appliance by pressing the
button.
8.
Carefully press the ingredients down with
the tamper (1).
9.
After use, switch off the appliance with the
button and pull the plug out of the
outlet.
Using the mincer:
EN
