CASO DESIGN 1863, Original Operating Manual

Page: 28 / 83

28
Filter
Warning
► The filter is only intended to filter tap water. Do not use water of unknown quality or that
has been microbiologically impaired.
1. Remove the filter from all packaging. There may be a small residue of black carbon
particles in the bag or adhering to the cartridge body. This is normal. These particles are
harmless and will be washed off during the preparation process.
2. Soak the filter upright in water for 10 min.
3. Rinse the filter under running water for 10 sec.
4. The filter is now ready for use.
Please note
► The lifetime of the filter lasts about 4-6 weeks of normal use (filtering of approximately 150
l water in total).
► Store the replacement filter cartridges in a cool location, out of direct sunlight and away
from heat sources.
14.2 Use
1. Fill in water
1. Open the lid, fill the water tank with the desired amount of water.
2. Close the lid.
Please note
► The water level must be less than the Max level.
2. Obtain desired water
1. Make sure the plug is connected to the wall outlet.
2. Place your cup on the removable drip tray, make sure it aligns with the spout.
3. First press about 3-5 seconds. and light up.
4. Press to choose your desired temperature and press to set the water volume.
5. Press to operate the appliance. After 5-10 s, the desired water will flow out
continuously from water spout. Press again, when your desired amount of water is
obtained. The appliance will stop working at once.
6.
If you want to obtain water again, repeat the steps above.
Please note
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The appliance has a memory function if the plug is still plugged in. The settings, that were
adjusted the last time, are still adjusted. The settings will be reset after unplugging.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.