13
3.5 Setup location requirements:
In order to ensure the safe and trouble-
free operation of the device, the setup
location must fulfil the following
prerequisites:
•
Only use this device on a flat, stable,
heat-resistant surface away from
water splashes and any heat
sources. Never use the device
outdoors and always place in a dry
environment.
•
Do not set up the device in a hot, wet
or extremely damp environment or
near flammable material.
•
Choose the setup location in such a
way that children cannot reach any
hot surfaces on the device.
•
Allow
6” clearance around the appliance
•
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup locations must be
carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
3.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
•
Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
•
The electrical outlet must be protected by a 16A safety cut-out switch.
•
The use of multiple plugs or gangs is prohibited because of the danger of fire that is
involved with this.
•
Make sure that the power cable is undamaged and has not been installed under the
device or over hot or sharp surfaces.
•
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
3.7 Rating plate
The rating plate with the connection and performance data can be found on the bottom of
the unit.
