Operation Guide 3068
4
Illumination
The watch has an EL (electro-luminescent) panel that
causes the entire display to glow for easy reading in the
dark. The watch’s auto light switch illuminates the display
automatically when you angle the watch towards your
face.
•
The auto light switch must be turned on (indicated by
the auto light switch indicator) for it to operate.
•
See “Illumination Precautions” for other important
information.
To turn on illumination manually
In any mode (except when a setting screen is on the
display), press
B
to illuminate the display.
•
You can specify 1.5 seconds or 2.5 seconds as the
illumination duration. See “To specify the illumination
duration” for more information.
•
The above operation turns on illumination regardless of
the current auto light switch setting.
Auto light switch
indicator
About the Auto Light Switch
Turning on the auto light switch causes illumination to turn on whenever you position
your wrist as described below in any mode. Note that this watch features a “Full Auto
EL Light,” so the auto light switch operates only when available light is below a certain
level. It does not illuminate the display under bright light.
Moving the watch to a position that is parallel to the ground and then tilting it
towards you at more than 40 degrees causes illumination to turn on.
•
Wear the watch on the outside of your wrist.
Parallel to
ground
More than
40°
Warning!
•
Always make sure you are in a safe place whenever you are reading the watch
using the auto light switch. Be especially careful when running or engaged in
any other activity that can result in accident or injury. Also take care that
sudden illumination by the auto light switch does not startle or distract others
around you.
•
When you are wearing the watch, make sure that its auto light switch is turned
off before riding on a bicycle, or operating a motorcycle or any other motor
vehicle. Sudden and unintended operation of the auto light switch can create a
distraction, which can result in a traffic accident and serious personal injury.
To turn the auto light switch on and off
In any mode (except when a setting screen is on the display), hold down
B
for about
two seconds to toggle the auto light switch on (auto light switch indicator displayed)
and off (auto light switch indicator not displayed).
•
The auto light switch indicator remains in all modes while the auto light switch is
turned on.
To specify the illumination duration
1. In the Timekeeping Mode, hold down
A
until the city
code starts to flash, which indicates the setting screen.
2. Press
A
two more times.
3. Press
C
twice to move the flashing to the seconds
setting.
4. Press
B
to toggle the illumination duration setting
between 2.5 seconds (
) and 1.5 seconds (
).
5. After the setting is the way you want, press
A
to exit
the setting screen.
lllllll
lllll
lll
lll
Power Supply
This watch is equipped with a solar cell and a special rechargeable battery (secondary
battery) that is charged by the electrical power produced by the solar cell. The
illustration shown below shows how you should position the watch for charging.
Example:
Orient the watch so its face
is pointing at a light source.
•
The illustration shows how to position
a watch with a resin band.
•
Note that charging efficiency drops
when any part of the solar cell is
blocked by clothing, etc.
•
You should try to keep the watch
outside of your sleeve as much as
possible. Charging is reduced
significantly if the face is covered only
partially.
Solar cell
Important!
•
Storing the watch for long periods in an area where there is no light or wearing it in
such a way that it is blocked from exposure to light can cause rechargeable battery
power to run down. Make sure that the watch is exposed to bright light whenever
possible.
•
This watch uses a special rechargeable battery to store power produced by the solar
cell, so regular battery replacement is not required. However, after very long use, the
rechargeable battery may lose its ability to achieve a full charge. If you experience
problems getting the special rechargeable battery to charge fully, contact your dealer
or CASIO distributor about having it replaced.
•
Never try to remove or replace the watch’s special battery yourself. Use of the wrong
type of battery can damage the watch.
•
The current time and all other settings return to their initial factory defaults whenever
battery power drops to Level 5 and when you have the battery replaced.
•
Turn on the watch’s Power Saving function and keep it in an area normally exposed
to bright light when storing it for long periods. This helps to keep the rechargeable
battery from going dead.
Battery Power Indicator and Recover Indicator
The battery power indicator shows you the current power level of the rechargeable
battery.
Function Status
All functions enabled.
All functions enabled.
Alarm, hourly time signal,
illumination, auto light switch,
and display disabled.
Except for timekeeping and
the
CHG
indicator, all
functions and display are
disabled.
All functions, including
timekeeping, disabled and
initialized.
Level Battery Power Indicator
l l l l ll
lll
ll
ll
ll
l l
l
Recover indicator
Battery power indicator
1
2
3
l l l l
ll
lll
ll
ll
l l
(Charge Soon Alert)
4
5
•
The charge indicator (
CHG
) at Level 4 tells you that battery power is very low, and
that exposure to bright light for charging is required as soon as possible.
•
At Level 5, all functions are disabled and settings return to their initial factory
defaults. Functions are enabled once again after the rechargeable battery is
charged, but you need to set the time and date, after the battery reaches Level 3
(indicated by the flashing
L
indicator) from Level 5. You will not be able to configure
any of the other settings until the battery reaches Level 2 (no charge indicator) after
dropping to Level 5.
•
Leaving the watch in direct sunlight or exposed to some other very strong light source
can cause the battery power indicator to show a reading that is momentarily higher than
the actual battery level. The correct battery power indicator should appear after a few
minutes.
•
If you use the light or alarms a number of times during a short period, the recover
indicator (
RECOV
) appears and the following operations become disabled until
battery power recovers.
Illumination
Beeper tone
After some time, battery power will recover and the recover indicator will disappear,
indicating that the above functions are enabled again.
Charging Precautions
Certain charging conditions can cause the watch to become very hot. Avoid leaving
the watch in the areas described below whenever charging its rechargeable battery.
Also note that allowing the watch to become very hot can cause its liquid crystal
display to black out. The appearance of the LCD should become normal again when
the watch returns to a lower temperature.
Warning!
Leaving the watch in bright light to charge its rechargeable battery can cause it
to become quite hot. Take care when handling the watch to avoid burn injury.
The watch can become particularly hot when exposed to the following
conditions for long periods.
•
On the dashboard of a car parked in direct sunlight
•
Too close to an incandescent lamp
•
Under direct sunlight
Charging Guide
After a full charge, timekeeping remains enabled for up to about eight months.
•
The following table shows the amount of time the watch needs to be exposed to light
each day in order to generate enough power for normal daily operations.
•
Since these are the specs, we can include all the technical details.
•
Watch is not exposed to light
•
Display on 18 hours per day, sleep state 6 hours per day
•
1 illumination operation (1.5 seconds) per day
•
10 seconds of alarm operation every other day
•
Stable operation is promoted by frequent charging.
Exposure Level (Brightness)
Outdoor Sunlight (50,000 lux)
Sunlight Through a Window (10,000 lux)
Daylight Through a Window on a Cloudy Day
(5,000 lux)
Indoor Fluorescent Lighting (500 lux)
Approximate Exposure Time
5 minutes
24 minutes
48 minutes
8 hours
Recovery Times
The table below shows the amount exposure that is required to take the battery from
one level to the next.
•
The above exposure time values are all for reference only. Actual required exposure
times depend on lighting conditions.
– – –
8 hours
41 hours
83 hours
Exposure Level
(Brightness)
Outdoor Sunlight (50,000 lux)
Sunlight Through a Window
(10,000 lux)
Daylight Through a Window
on a Cloudy Day (5,000 lux)
Indoor Fluorescent Lighting
(500 lux)
Approximate Exposure Time
Level 5
Level 4
Level 3
Level 2
Level 1
2 hours
6 hours
10 hours
126 hours
18 hours
91 hours
184 hours
▲
▲
▲
▲
▲