General Guide
E-4
Use the number buttons and the [–] and [+] buttons to change
the settings of the parameters that appear in the upper left
area of the display.
Use the number buttons to enter numbers and values.
• Enter the same number of digits as the currently displayed
value.
Example:
To enter tone number 005, input 0
3
0
3
5.
• Negative values cannot be input using the number buttons.
Use [+] (increase) and [–] (decrease) instead.
You can use the [+] (increase) and [–] (decrease) buttons to
change the displayed number or value.
• Holding down either button scrolls the displayed setting.
• Pressing both buttons at the same time will revert to the
initial default setting or the recommended setting.
Use the Setting button (
4
) to access settings that let you
select the reverb type, pedal effect, etc.
1.
Press
4
.
2.
Next press
4
until the parameter whose setting
you want to change is displayed.
Each press of
4
cycles through the available parameters.
3.
When the parameter you want is displayed, use
bo
(10-key) to change its setting.
• The parameter setting will disappear from the upper left
area of the screen if you do not perform any operation
for some time.
• The tone and other parameters revert to their initial
defaults whenever you turn on power (page E-6).
Using the 10-key Pad (
bo
)
Number Buttons
[–] and [+] Buttons
M d e r n P n o
Setting
Using the Setting Button (
4
)
Parameter
Display
See Page
1
Transpose
Trans.
E-12
2
Accompaniment Volume
AcompVol
E-31
3
Song Volume
Song Vol
E-17
4
Touch Response
Touch
E-8
5
Tuning
Tune
E-12
6
Reverb
Reverb
E-11
7
Voice Fingering Guide
Speak
E-22
8
Note Guide
NoteGuid
E-23
9
Performance Evaluation
Scoring
E-23
10 Phrase
PhraseLn
E-23
11 Sampling Start
SmplAuto
E-13
12 Keyboard Channel
Keybd Ch
E-33
13 Navigate Channels
Navi. Ch
E-33
14 Local Control
Local
E-34
15 Accomp Out
AcompOut
E-34
16 Pedal Effect
Jack
E-11
17 Power On Alert
Demo2
E-6
T r a n s .
Parameter
Setting
