19
Quick Start Basics
You can use either of the two following methods to charge the battery. Before
charging the battery, use the procedure under “Opening and Closing the Frame”
(page 14) to open the frame.
• USB-AC adaptor
• USB connection to a computer
.
To charge with the USB-AC adaptor
While the camera is turned off, connect in the sequence shown below (
1
,
2
,
3
,
4
).
Charging time: Approximately 130 minutes.
IMPORTANT!
• A battery that has not been used for a long time or ambient temperature extremes
can cause charging to take longer than normal. If charging takes longer than about
six hours, a timer will terminate it automatically, even if the battery is not fully
charged. This is indicated by the back lamp flashing red. If the battery has not been
used for a very long time, charging may be terminated automatically and the back
lamp may start flashing red after only about 45 minutes. In either case, disconnect
the USB cable from the camera and then reconnect it to resume charging.
First, charge the battery prior to use.
The built-in rechargeable lithium ion battery of the camera is not charged when you
purchase it. Perform the steps below to charge the battery before using the
camera.
4
3
2
1
USB cable
(included with camera)
Making sure that the
8
mark on the USB cable connector is towards the side opposite
that of the monitor screen, connect the cable to the camera.
[USB] port
USB-AC adaptor
Power cord
