DT-X200 Hardware Manual
P.18
3.1.2. Ethernet Cradle/ USB Cradle
Specification
Remark
Interface to DT-X200
Type
Contact Connector
Communicate and power supply
to DT-X200
Refer ＊１
Baud rate
Full speed (12Mbps)
Protocol
IEEE 802.3 Standard
Connector
USB connector A type
1 VBus
2 USB D-
3 USB D+
4 GND
Baud rate
Full speed (12Mbps)
Low speed not supported
Power to external
device
5V±5%, 500 mA (maximum)
USB Client
Connector
USB connector B type
1 VBus
2 USB D-
3 USB D+
4 GND
Baud rate
Full speed (12Mbps)
Low speed not supported
Input voltage
DC 12V±5％
Adaptor
AD-S42120C
Input voltage
DC 5V±5％
Adaptor
AD-S15050B
Input from AC Adaptor
(USB Cradle)
Item
Input from AC Adaptor
(Ethernet Cradle)
USB Host
LAN
(Only Ethernet Cradle)
4
1
3
2
1
2
3
4
＊
1
Pin Layout
The pin layout below shows when the cradle is viewed at its front.
Pin Layout and the description
Pin no.
Signal
Description
Direction
1
V CRADLE
Power supply to the terminal and charge to
battery pack installed in the terminal.
-
2
D +
USB D +
IN/OUT
3
D -
USB D -
IN/OUT
4
USB_ID
Switch-over between USB host and USB
client
OUT (Note 1)
5
V BUS
Power from/to USB cradle
-
6 GND
GND
-
Notes:
1.
The output is made from the cradle. The direction “OUT” is for USB mode, or “IN” for LAN mode.
CASIO COMPUTER CO., LTD.
