E-25
Performing a Bar Code Read Operation
1
Press the [PW] key to turn power on. Hold the
Data Collector close to the bar code and
press the trigger key.
2
The reader port emits a laser to read the bar
code. The read indicator lights green when
the read is successful.
Important!
• If you have problems with the read operation, change the angle between
the label and Data Collector, or move closer and then try again.
• If the bar code is larger than the diameter of the Data Collector’s reader
port, try moving the Data Collector a bit farther away from the bar code.
• The Data Collector should be able to read a bar code from the
maximum distance of 38 centimeters on the forward-facing reader port
model and about 30 centimeters on the down-facing reader port model
under the following conditions.
Ambient Light: 500 lux (fluorescent)
PCS: 0.9 min.
Minimum Bar Width: 1.2 mm
ITF (extended version)
• Wavelength: 650 nm
Maximum output: 1.0 mW
• CAUTION
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
Using the Bar Code Reader
Reader port
Read indicator
Trigger key
Power key
Maximum distance:
Approx. 38 cm
(forward-facing
reader port model)
and approx. 30 cm
(down-facing reader
port model)
EXPLANATORY LABEL
DT-900 M50E
DT-900 M51E
EXPLANATORY LABEL
DT-900 M60E
DT-900 M61E
