Quick
Start
3. Press
the
Clear
key.
4. Select
1: yes
.
5. Press
the
Clear
key to return to the system menu.
6. Select
4: Transmit
,
4: Utility
and
4: Change memory size
.
7. Enter
640
and then press
the
Enter
key.
8. Select
yes
to change the size.
9. Press
the
Clear
key to return to the system menu.
10. Select
1: Execute AP
.
11. Select
Enter
for “yes” to execute the AP.
The terminal is now configured to accept a download from Twin Client Manager.
Starting a Telnet Session
At the Twin Client main menu on the terminal, press any key to establish the connection.
Until the terminal has been authorized, the following screen is displayed.
RECOVERABLE ERROR
Terminal not
Authorized for
Twin Client
Keypress to Continue
It is not necessary to authorize the terminal at this time, so press any key to continue. The
terminal will establish a connection with the host system and start emulation. If the
terminal fails to connect to the host, refer to the following table for the possible causes
and the related corrective actions.
Failure Cause
Corrective Action
Incorrect Host IP address Correct the Host List address on the terminal. Refer to
Terminal Setup Using Twin Client Menus
under
Standard
Setup
for instructions.
Incorrect netmask value
Access Radio Setup menu and correct the netmask value.
Refer to
Terminal Setup Using Twin Client Menus
for
instructions.
After a Telnet session has been successfully established, the terminal will remain in
session for a maximum of 30 minutes at a time until it has been authorized. Once
authorized, there is no software restriction on the session time. The instructions for
authorizing the terminal are presented in
Authorizing PowerNet
.
Supported Equipment Manual
•
March, 2006
2-11
