CDP-120
– 22 –
<Installing the hammers>
Be sure to install each hammer at its designated location. If a hammer does not move smoothly,
check if it is installed at the correct location.
Follow the same procedures shown below to install a hammer for both black and white keys.
(1) Use the tweezers to set a hammer at its correct location.
(2) Press the chassis with the tip of tweezers.
(3) Using the chassis-tweezers contact as a fulcrum point, press down the metal part of the
hammer in the direction of the red arrow in the illustration below, and then install the
hammer.
NOTE:
When installing, do not damage the felt.
Be careful not to damage the felt.
Press down against the metal part.
Tweezers
Fulcrum point
Locked at this point
Summary of Contents for CDP-120
