Xiamen Cashino Technology Co., Ltd.
LP-56 Thermal Label Printer
9
4.2 Printer status description
The printer has three indicator lights, namely the power indicator light, the error indicator light, and
the Bluetooth indicator light.
POWER indicator
(Green)
STATUS indicator
(Red)
buzzer
Printer status
Keep bright
Working properly
Keep bright
Flash 3 times
3 beeps
No paper
Keep bright
Flash 5 times
5 beeps
Printer head over heating
Keep bright
Flash 6 times
6 beeps
Platen not pressed down
4.3 paper feeding
(1) Load the thermal label paper roll into the paper roll
Note:
The paper roll should fall to the root of the paper roll; the paper runs in the direction shown in
the figure during printing. Pay attention to the direction of the paper roll when installing.
(2) Turn the cover opening knob to open the upper cover of the print head
(3) Peel off a few sheets of labels at the end of the thermal label paper, and the length of the backing
paper after peeling is about 200mm. Then, as shown in the figure below, pass the thermal label paper
around the pressing shaft and pass it into the paper passage from the opening of the paper passage.
The first label is pressed on the printing rubber roller.
Note: Make sure that the bottom edge of the paper reaches the support board, and the end of the
first label should not exceed the peeling knife in front of the printing rubber roller.
(4) Close the upper cover of the print head, and adjust the paper adjustment block up and down to a
suitable position according to the width of the thermal label paper. Generally, it is recommended to adjust
it to 0.5-1mm wider than the paper.
(5) Turn the backing paper of the thermal label paper around the peeling knife, the printing rubber
