CCE - Cash Concepts Europe GmbH
Kemptener Straße 99 – D-88131 Lindau / Germany
Tel.: +49 (0)8382 – 943 15 – 0 / Fax: +49 (0)8382 – 943 15 – 20
Email: [email protected] / Web: www.cce.gmbh
EN
Date setting
Hold down the "↑ / SET" button and select by repeatedly
pressing the "PAGE" button the date display.
Pressing
the "↑ / SET" and "↓ / BAT" key to set the date and
time. With the key "REP / PRT" you switch between the
different positions in the display back and forth.
By pressing the "Start-Stop" button, the set values are stored.
2016-07-05
08:58
00
BLT: 82894
Printer setting
Hold down the "↑ / SET" button and select by pressing the
"PAGE" button the printer display.
Pressing the "↑ / SET" and "↓ / BAT" buttons to select the
installed or connected printer. Please note that only by
CashConcepts offered printers were used. For all other
printers no support is offered.
By pressing the "Start-Stop" button, the set values are stored.
Printer Model:
SP-RMD8 (IN) v
RDTH32SC (OUT)
SP-POS58V (OUT)
Fault management and maintenance
Transport brush
The transport and sorting brush is designed for the processing of one million coins, the lifetime is limited through the wear our by
the transport of the coins. After processing of 400,000 coins you receive the message "Please remove the gasket". Than you need
to remove a metal ring so that the wear is compensated. After a million of processed coins you receive the message "Please
replace the brush" that the brush should be replaced.
To remove a metal ring, please proceed as follows.
Lift the coin slider up and remove the safety pin.
Loosen by turning to the direction of "+" the
determination wheel and unplug the brush.
Remove the thin metal plate and store it when a
new brush is installed, this disc has to be reissued.
Install the brush and fix it with the safety pin.