0A-4 General Information
If more than 7 minutes passes, remove the
previous liquid gasket and re-apply it.
6. Please wait for at least 30 minutes since the last
part is installed before starting the engine.
Liquid gasket
• Always use the liquid gasket products listed above,
or a liquid gasket identical to the ones listed above.
• Use the correct quantity of liquid gasket. Always
follow the handling instructions for each product.
Application procedure
1. Wipe the contact surfaces clean of all water, fat or
oil. The contact surfaces should be dry.
2. Apply a regular bead width of liquid gasket to one
of the contact surfaces. Make sure that the bead
does not break at this point.
Notes:
If there are special regulations concerning the
application procedure in the repair document, please
follow those regulations.
Work procedure
1. Wipe the joint surfaces of the bolt, bolt hole, and
screw thread section clean of water, fat, and oil.
The contact surfaces should be dry.
2. Apply Loctite to the top 1/3 of the screw.
3. Tighten the bolt to the correct tightening torque.
Important:
After tightening the bolt, do not apply excessive torque
or try to rotate the bolt until at least one hour has
passed, and the Loctite has hardened.
Procedure for using the Plastiguage
Example: Procedure for measuring the clearance
between the connecting rod bearing and crank pin.
• Clean the connecting rod and bearing, and install
the bearing to the rod.
• Cut the plastiguage to the same width as the crank
pin, and while avoiding the oil pore of the crank pin
lay the gauge parallel to the pin.
Seal section
Product name
Manufacturer's name
Between cylinder block and – Flywheel housing
1207B
Three Bond
Between cylinder block and – Flywheel housing and –
Crankcase
1207B
Three Bond
Between cylinder block and – Crank case
1207B
Three Bond
Between cylinder block and – Front cover
1207B
Three Bond
Cylinder block, head plug nipple, unit, switches
262
Loctite
Type
Measurable range mm (in)
PG-1 (Green)
0.025 – 0.076 (0.001 – 0.003)
PR-1 (Red)
0.051 – 0.152 (0.002 – 0.006)
PB-1 (Blue)
0.102 – 0.229 (0.004 – 0.009)
Find manuals at https://best-manuals.com