General Information 0A-3
8. Always check that there are no fuel leaks when
performing maintenance work on the fuel system.
(It may cause a fire.)
9. Pay close attention to the risk of ignition if you are
handling parts that carry a high voltage.
Furthermore, any oil or fat spilt onto rubber parts
must be wiped off immediately, as it will cause
deterioration of the rubber.
Replacement parts and part numbers.
1. Always replace packing, oil seals, o-rings, caulking
lock nuts, folding lock plates, split pins and other
such parts with brand new parts.
2. The parts numbers contained in this manual may
not represent the supply condition of the parts, and
the part numbers may be changed due to
revisions. Therefore, parts should always be
checked against a parts catalogue before use.
Liquid gasket
1. Each time you disassemble parts that use liquid
gasket, completely remove the old gasket residue
from each of the parts and matching sections using
a scraper, then clean each of the parts to
completely remove oil, water, and dirt etc. from the
various surfaces. Using the specified type of liquid
gasket, apply new liquid gasket to each of the
surfaces before reassembling the parts.
2. In order to make it easier to clean liquid gasket
surfaces, apply gasket remover liquid (Pando-
391D made by Three Bond Co., Ltd.) and leave
the part to stand for approximately 10 minutes,
after which the old liquid gasket residue will be
easier to remove.
However, this should not be used on resin
components or painted components.
3. Please take care not to apply too much or too little
liquid gasket.
Also, you should always re-apply the liquid gasket
upon itself when you start and finish application.
4. Make sure that there are no gaps when re-
installing the liquid gasket parts to each other. If
there are gaps between the two parts, re-apply the
liquid gasket. Some parts, especially the oil pan,
use the same size studs as a guide to eliminate the
need for knock pin positioning etc.
5. Re-install these parts within 7 minutes of applying
the liquid gasket.
Find manuals at https://best-manuals.com