Case IH FARMALL 110U, Service Manual

Page: 50 / 81

Engine - Engine and crankcase
4. Use a strap wrench to remove the engine oil filter
(3) .
5. Clean the mounting surface of the new filter.
6. Lightly oil the seal of the new filter with clean oil.
7. Screw the new filter until the seal contacts the
mounting surface. Then screw further 3/4 turn or
at most one full turn.
8. Dispose of the filter replaced and the oil that flowed
out during the operation according to current regu-
lations.
MOIL15TR01725AA
4
To top up with new engine oil, proceed as follows:
1. Retighten the drain plugs (1) that were previously
removed.
2. Fill with new oil CASE IH AKCELA UNITEK NO.
1™ SBL CJ-4 SAE 10W-40 or CASE IH AKCELA
UNITEK NO. 1™ SSL CJ-4 SAE 0W-40 through
the filler neck (2) .
3. Run the engine for at least three minutes.
4. Shut down the engine.
5. Wait five minutes to allow the oil to return to the
sump.
6. Check that the oil level is between the MIN and
MAX notches on the dipstick under the filler neck
cap
(2) .
7. if necessary, top up with oil to reach the level.
8. Tighten the filler cap (2) .
MOIL14TR01270AA
5
NOTE: replace the fuel filters before refitting the bracket (2) figure 3 and the side panel (2) figure 2 .
NOTE: Do not fill above MAX notch on the dipstick. Excess oil burns, creates smoke and gives a false indication of
oil consumption. Do not operate the engine if the oil level is below the MIN notch on the dipstick.
48038069 02/10/2017
10.1 [10.001] / 23