Case IH 105C, Service Manual, Page: 40 / 51

Engine - Engine and crankcase
21. Disconnect the hoist chains. Remove the jack stand
(2) previously fitted under the clutch case (1) . Retrieve
the movable tool for dismantling tractors.
WLAPL4S10C129A
12
22. Refit the bracket (2) supporting the cab connectors,
cab power and cup filter (3) . Connect the pipe that
joins the latter to the mechanical priming pump on the
sediment filter.
23. On the left-hand side, connect the cab power cable
connector (1) . Put the connector on the maxi fuse box
and lock with clamps.
WLAPL4S10C139A
13
24. Return the main engine cable (3) back into position.
Connect the sensors and switches located on the en-
gine, the connectors
(4) on the controller (5) and on
the maxi fuse compartment. Fasten the wiring with
clamps.
25. Lay out the FTP interface - engine cable (1) on the
machine. Reconnect the various connections (2) . Se-
cure the wiring with clamps.
WLAPL4S10C137A
14
26. Refit the starter motor (2) . Then connect the ground
cable of the engine and battery system. Secure the
ground cable with the bolt
(3) .
27. On the right-hand side, reconnect the battery positive
cable and the wirings to the starter motor, battery cut-
off switch and alternator. Refit the shroud
(1) on the
starter motor (2) .
WLAPL4S10C135A
15
47840678 10/03/2015
10.1 [10.001] / 17