Case HI C4013HGHG, User Manual

Page: 12 / 28

12
6.
Attach the other end of the high pressure hose to high pressure outlet (“A” on
diagram below) on pump. Pull down on collar of quick-connect, slide onto pump and
let go of collar. Note that some pumps require the hose to be threaded on. Tug on the
hose to ensure connection is secure.
7.
Turn water supply on if you have not already done so. Point the gun in a safe direction
and squeeze the trigger to purge the pump of air and debris. Do this until water flow
is no longer erratic. Continue to hold trigger of gun down while starting the machine
to ensure there is no pressure build-up.
8.
Take a final look at all connections to make sure there are no leaks or loose
connections. If there are any leaks in hoses, they must be replaced.
IMPORTANT : DO NOT siphon standing water for the water supply.
*Pump Uses SAE30 Non-Detergent Mineral Oil
START-UP & OPERATION (CONT.)
A
B
triplex pump
10.
To start the machine, locate the electric ignition switch on the right side of the
engine. Insert the key and turn it to the “ON” position” until the unit starts. Do not
hold the switch to the “ON” position for more than 5 seconds as this can cause
damage to the engine. Check to ensure fuel valve is in the ON position and if starting
cold, move the choke lever to the “CLOSED” position. Reference the component
diagram below for the location of these parts.
11.
If desired, the unit can also be started via the recoil starter. Ensure the fuel valve is
open and the choke is applied. Then, pull on the cord until resistance is felt, and then
pull the cord briskly. Return the cord to the engine by hand. Do not let it snap back
against the machine. Once the unit is running, it is now operating as a cold water ma-
chine.
Regardless of the starting method, remember to gradually move the choke lever back
to the “open” position once the engine is running.
*Engine Uses SAE 10W30 Oil