CASE CONSTRUCTION CX75C SR, Operator'S Manual

Page: 191 / 256

6 - MAINTENANCE
Every 500 hours
Engine oil and filter
To replace the engine oil and engine oil filter proceed
as follows:
1. Park the machine on flat, level ground. Stop
the engine, remove the ignition key then open
the hatch under the engine.
2. Raise and fasten the engine hood with the
brace, then remove the filling plug.
SMIL13CEX2782AB
1
3. Remove the protective cap from the engine
housing drain valve.
4. Screw the end of the extension drain hose into
the drain plug, then place the other end in a
container of appropriate capacity and allow the
oil to flow out.
5. Remove the extension drain hose, then install
the protective cap on the housing check valve.
Place the extension drain hose in the storage
compartment at the front.
NOTE: change the oil while the engine is still warm. The
oil will flow more easily.
SMIL13CEX2801AB
2
6. Clean around the filter at the rear right com-
partment and remove it with the special oil filter
wrench.
SMIL13CEX2802AB
3
6-45