4. Wind the line anti-clockwise around
the spool leaving a length of line (approx.
.2inches).
5. With the length of line left insert it in to
the hole of the inner cover and then replace
the cover back on to the spool.
6. Push the spools back into the spool
holder and tighten clockwise ensuring it is
located securely in place.
CAUTION.
After changing the line spool,
run the trimmer under no load for at least
a minute to make sure that the line and
the tool are both operating correctly. Use
only the line spool as recommended by the
manufacturer.
LUBRICATION AND SERVICE
1. There are no parts that require lubrication
for normal use.
2. When the line trimmer needs new carbon
brushes or after 40 hours of use, take
it to an authorized service center for the
replacement of the carbon brushes and the
following:
•Lubrication
•Mechanical drive check including spindle,
bearing and enclosure
•Electrical circuits check including switch,
wiring and motor.
•Mechanical and electrical performance
CAUTION. Do not use cleaning agents to
clean the plastic parts of the tool. A mild
detergent on a damp cloth is recommended.
Water must never come into contact with
the tool. Do not use this trimmer in wet
rainy conditions.
STORAGE
1. Store the trimmer away from direct
sunlight.
2. Do not store in a nylon bag as this can
encourage formation of mould.
3. At the end of the season, give the trim-
mer an overall cleaning and a thorough
check.
Do not leave the trimmer resting on the floor
for extended periods as it could cause the
shape of the guard to alter, posing a safety
risk. Hang it off the floor by the top
handgrip.