switch off, remove the plug from the power
point and replace the spool.
• Do not use the machine to cut grass,
which is not on the ground. For example, do
not cut grass, which is on walls or rocks.
• Do not switch on the machine in enclosed
or poorly ventilated spaces or in the pres-
ence of inflammable and /or explosive sub-
stances such as liquid, gases and powders.
• Always stop the trimmer and switch off
at the mains when cutting is delayed or
when walking from one cutting location to
another.
• Do not cross roads or gravel paths with
machine still running.
• After use, disconnect the machine from
the power supply and check for damage. If
you have the slightest doubts, check with
the authorized service center.
• Only use the machine according to the
instructions give in this manual.
• Do not extend the trimming line beyond
the guard and do not operate the trimmer
without both lines extended and proper line
installed.
• Check regularly that the nuts, bolts and
screws are tight.
IV Assembly
1.ACCESSORY LIST
The trimmer is accompanied
1. Guard
2. Screw 4X18 Safety Bolts
Fig 2
Fig. 3
2.ASSEMBLY OF GUARD
The only assembly required for your trim-
mer is to install guard and Insert the Middle
Tube3
1), Place the Safety Guard on the Motor
Housing head.
2), turn the Safety Guard to have the hole in
the Safety Guard to fit the screw hole in the
Motor Head and lock it.
3.INSERT THE Middle TUBE
1), Insert the Middle tube3 to the Main
Handle and Motor Housing in Position.
2) tightening it with 2 Tapping Screws 4X18
to lock it
Fig 4